The post
I'm a home builder, and after seeing [this post about scanning a house with a consumer 360 camera](https://www.reddit.com/r/GaussianSplatting/comments/1wmlobx/scanning_houses_just_got_10x_cheaper/), I wanted to try it on one of our model homes.
I started with a couple of office scans, worked through the photographer/selfie-stick masking issues, then went for a full bungalow, including the stairs down to the basement landing.
**Interactive tour:** [https://superspl.at/scene/ec360c12](https://superspl.at/scene/ec360c12)
What interests me as a builder is being able to free myself from expensive hardware and proprietary systems and just go out there and do it myself.
For anyone interested in the setup:
* **Capture:** 1,185 DJI Osmo 360 II photos at 30 MP (120 MP somehow yielded worse results), with exposure and white balance locked. These were stitched panoramas.
* **Masking:** SAM3 for the photographer, hands and selfie stick, followed by mask review and custom Python corrections.
* **Reconstruction:** Spirula Studio for camera alignment and Gaussian splat training, with MoGe2 surface normals. 1,153 photos aligned successfully.
* **Hardware:** RTX 4070 and 128 GB RAM. The shared model is the **50,000-step** local run, with approximately **2.97 million splats**. Training itself took about **4 hours 44 minutes**, excluding preprocessing and export.
* **Browser export:** PlayCanvas SplatTransform, with multiple levels of detail and streamed SOG. The raw PLY was about **737 MB**; the cleaned streaming package is about **113 MB**.
* **Cleanup/navigation:** Targeted removal of doorway floaters, plus separate voxel collision geometry for a level walking floor and barriers at the glass and patio doors.
One result surprised me: I also tested an **80 GB H100 on Lambda**, using the same prepared images and 50,000 steps but allowing a much larger model... about **14.7 million splats**. The visual improvement was small, so I kept the local version for sharing. That bigger run didn't deliver the quality jump I was hoping for.
There are still obvious weaknesses: soft fine details, reflections, thin objects and some blown-out windows. The scale is approximate, and accurate measurements and dependable floor plans are still separate problems to solve.
But getting this far with a consumer 360 camera, a desktop GPU and a browser viewer has me wanting to take it much further. My goal is a repeatable capture-to-tour workflow that we can use for actual houses.
**For those scanning interiors: what would you change first to improve this? Capture technique, camera alignment, or the training setup?** I'd especially appreciate advice on mirrors, windows and keeping small details stable as you move.
View the original thread on Reddit →